Internal ethernet adapter not working
- Vous devez vous identifier ou créer un compte pour écrire des commentaires
I'm very happy with Triskel 11 but my internal ethernet on an Acer Travelmate 5760 is not working.
Can you help me find the adapter I need to install please.
Hello, did you already tried to setup your network connection with nm-connection-editor?
Edit: or with KNetworkManager if you are using Triskel
an alternative is to list network interfaces with
ip link show
This is what I get with ip link show:
1: lo: mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: wlp7s0: mtu 1500 qdisc noqueue state UP mode DORMANT group default qlen 1000
link/ether 0c:60:76:54:08:d8 brd ff:ff:ff:ff:ff:ff
On my computers, with that command, ethernet interfaces show up with a name such as eno0, or eno with a number attached.
Can you find your ethernet controller with "sudo lshw"? In my laptop, it shows up as:
*-network
description: Ethernet interface
product: 82567LF Gigabit Network Connection
vendor: Intel Corporation
physical id: 19
bus info: pci@0000:00:19.0
logical name: eno0
version: 03
serial: cc:52:af:ce:b6:29
capacity: 1Gbit/s
width: 32 bits
clock: 33MHz
capabilities: pm msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=e1000e driverversion=5.15.0-76-generic firmware=1.8-3 latency=0 link=no multicast=yes port=twisted pair
resources: irq:30 memory:98700000-9871ffff memory:98724000-98724fff ioport:1000(size=32)
No network for Ethernet comes up.
> No network for Ethernet comes up.
If you mean that you can't see any ethernet adapter with "sudo lshw", there may be a hardware problem with the internal ethernet adapter in your laptop, perhaps a physical connection problem.
Yeah it's an old laptop and may not be connecting or some wire is loose.
- Vous devez vous identifier ou créer un compte pour écrire des commentaires