Revision of Full Disk encryption install from Sat, 02/27/2010 - 07:06

Introduction

We will install Trisquel in an encrypted hard drive:

• swap will be encrypted
• root (/) will be encrypted
• boot (/boot) cannot be encrypted but could be on an USB key or non-re-writable CD-ROM (not covered here)

Instructions

• Boot the LiveCD
• Connect to the network using NetworkManager (located on the far-right side of the Panel)
• Open the terminal and become root:

sudo su

• Install cryptsetup and gparted:

apt-get update
apt-get install gparted
apt-get install cryptsetup

• Launch gparted and partition your hard disk like you would do normally (so create filesystem on the partition etc...) creating unencrypted valid partitions

• Use Wikipedia to find the best block cypher around. I used aes,xts,essiv:256
• Load the modules of the chosen encryption:

modprobe xts
modprobe aes_i586
modprobe sha256

Note that I aes_i586 is an optimized version of aes for i586 or later X86 CPU

• Format the partition you have chosen for root(/) with cryptsetup:

cryptsetup -y --cipher aes-xts-essiv:sha256 --key-size 512 luksFormat /dev/PARTITION

replace /dev/PARTITION by your partition. It will overwrite all the data in the partition.

• Open the partition (replace /dev/PARTITION as needed):

cryptsetup luksOpen /dev/PARTITION crypto_root

• Format the partition using the filesystem you want (preferably ext4, or XFS if you do not mind the fact that partitions cannot be shrunk in XFS):

mkfs.ext3 /dev/mapper/crypto_root

• Launch the Trisquel installer and proceed to step 4, hard disk partitioning
• Select manual partitioning, then select your root (/) partition to be /dev/mapper/crypto_root
• Select your swap and your /boot partitions in the same manner
• Be careful not to recreate the partition table
• Proceed with installation. When it finishes, tell the installer that you want to continue trying Trisquel, not to reboot.
• Mount your root partition and chroot into it:

mkdir /mnt/root
mount /dev/mapper/crypto_root /mnt/root
mount /dev/ /mnt/root/dev -o bind
chroot /mnt/root mount /proc
chroot /mnt/root mount /sys
chroot /mnt/root

• Create the /etc/crypttab replacing /dev/PARTITION as needed:

echo "root /dev/disk/by-uuid/$(sudo vol_id --uuid /dev/PARTITION) none luks" >> /etc/crypttab

• Add the cypher modules you have chosen before to /etc/modules so they load at boot and get included in the initd:

echo xts >> /etc/initramfs-tools/modules
echo aes_i586 >> /etc/initramfs-tools/modules
echo sha256 >> /etc/initramfs-tools/modules

• Install cryptsetup:

apt-get update
apt-get install cryptsetup

• Rebuild the initrd:

mount /boot
update-initramfs -u

• Exit the chroot and unmount everything:

exit
umount /mnt/root/boot
umount /mnt/root/proc
umount /mnt/root/dev
umount /mnt/root/sys

• Finally, reboot Trisquel. You will be asked for your hard disk encryption password.